newbie who knows little about lr's

Land Rover Forums Land Rover Classifieds Photo Gallery Member List Calendars Search Contact Us Sponsors
Land Rover Lineup News Forum FAQ Land Rover Recalls TSBs Timeslips Register Login

newbie who knows little about lr's

Printable Version

Land Rover Forums >> General Land Rover Forums >> General Tech Help >> newbie who knows little about lr's

Page: [1]

Message

<< Older Topic Newer Topic >>

newbie who knows little about lr's - 1/3/2007 2:25:10 PM

zak

Posts: 1
Joined: 1/3/2007
Status: offline

Hi, not sure if what im going to say will make any sense, but here goes! my bruv in law's head gasket went back in september, got it fixed...no probs. Now three months down the line its gone again, hes spoken to the mechanic who said its either one of two things. either it was a faulty gasket or the cylinder has a hairline crack in it. can anyone tell me if, when replacing the gasket a pressure check would be done on the cylinder as a matter of course or not. the mechanic said that because the engine was spotless the cylinder looked ok, so therefore didnt do the pressure check.
the land rover he has is a series 1 TDI M reg with a recon engine. would appreciate any replies. thanks

Post #: 1

RE: newbie who knows little about lr's - 1/3/2007 4:42:54 PM

Disco Mike

Posts: 9370
Joined: 4/27/2006
Status: offline

Time for a compression test and leak down test. Did the mechanic use new head bolts?
The head should have been inspected just to be safe. Will be interested to see what they find.
Mike

(in reply to zak)

Post #: 2

RE: newbie who knows little about lr's - 1/19/2008 1:00:14 PM

DiscoSam2

Posts: 33
Joined: 2/4/2007
Status: offline

I had my head gasket go out after 3 months,found out I needed to have block decked,if thats the case being a voice of bad experiance just buy new bottom end

(in reply to Disco Mike)

Post #: 3