1964 series IIA brake wount bleed need help

Land Rover Forums Land Rover Classifieds Photo Gallery Member List Calendars Search Contact Us Sponsors
Land Rover Lineup News Forum FAQ Land Rover Recalls TSBs Timeslips Register Login

1964 series IIA brake wount bleed need help

Printable Version

Land Rover >> General Land Rover Forums >> General Tech Help >> 1964 series IIA brake wount bleed need help

Page: [1]

Message

<< Older Topic Newer Topic >>

1964 series IIA brake wount bleed need help - 3/23/2007 2:19:12 PM

ste

Posts: 1
Joined: 3/23/2007
Status: offline

series IIA year1964 cb type master cylinder non servo my brakes will not work just fited new master cylinder and blead them carnt get eney presher on brake pedle can eney one help

< Message edited by ste -- 3/23/2007 5:28:59 PM >

Post #: 1

RE: 11A brake wount bleed - 3/23/2007 4:47:57 PM

cold_surfer

Posts: 88
Joined: 3/15/2007
Status: offline

Did you bleed the master cylinder first? run line from the output back into the master resovouir and bleed all the internal air first. Then do the lines going to the calipers.

If this post was about the DISCO or ROVER I'd say ABS sometimes requires VACUUM to evacuate and bleed the system. ABS systems are different than the old/regular systems since there is a motorized/pressurized pump system that takes over when you apply brakes and the wheel speed sensors detect wheel lockup or difference between engine/trans speed and wheel speed.

_____________________________

Melbourne, Florida - Space Coast Rovers Club Member
93 RR SWB, 2" lift, Mantek Snorkel, 10K winch
93 RR LWB stock + mastercraft MT 245/75 E

(in reply to ste)

Post #: 2