gearbox problem I think

Land Rover Forums Land Rover Classifieds Photo Gallery Member List Calendars Search Contact Us Sponsors
Land Rover Lineup News Forum FAQ Land Rover Recalls TSBs Timeslips Register Login

gearbox problem I think

Printable Version

Land Rover Forums >> Vehicle Line Up >> Range Rover >> gearbox problem I think

Page: [1]

Message

<< Older Topic Newer Topic >>

gearbox problem I think - 5/11/2007 2:35:03 PM

shadow

Posts: 3
Joined: 5/11/2007
Status: offline

Hi I have a 95 4.6 HSE auto. I was driving and the dash displyed transfer neatual. i stopped done it then put it into D it said it again i drove it home about 6 miles staying under 30 mph. Turned the car off and left it for 5 hours or so. got in started it up selected D nothing no R no 1/2/3 nothing. Put it into P and it sounded like a manual going into gear without the clutch. Turned the car off put into P turned back on disply says transfer N. select N try to go back to P same noise. I think this could be electric problem!! Well thats what i hope. The thing is I have no idea where to start. I would be gratefull for any advise. As long as it does not include the use of a very large hammer while screaming like a banchee LOL.

Post #: 1

RE: gearbox problem I think - 5/11/2007 6:15:47 PM

Disco Mike

Posts: 10374
Joined: 4/27/2006
Status: offline

Send me your tele number and a good time for me to call you.
Mike
mikeljacobs@comcast.net

(in reply to shadow)

Post #: 2

RE: gearbox problem I think - 5/12/2007 5:44:32 AM

shadow

Posts: 3
Joined: 5/11/2007
Status: offline

thanks for replying i have sent you an email.
i looked under the seat and checked all the connections and they seem to be fine.
i put a fuse into the slot that is for towing the car as it seems to think that is what i want to do, left it running for a while then took it out, it now tells me to select neatual which appears to be different from the first problem so i think it must be electrical or computer problem.
i have also found that pushing the memory seat button once does not set the seat what i have to do now is hold it in until it stops moving. could this be linked?
if so could it be a BCEM fault?
many thanks in advance for any help
mark

(in reply to shadow)

Post #: 3