1990 rover

Land Rover Forums Land Rover Classifieds Photo Gallery Member List Calendars Search Contact Us Sponsors
Land Rover Lineup News Forum FAQ Land Rover Recalls TSBs Timeslips Register Login

1990 rover

Printable Version

Land Rover >> General Land Rover Forums >> New Member Introduction >> 1990 rover

Page: [1]

Message

<< Older Topic Newer Topic >>

1990 rover - 8/28/2007 9:57:08 AM

newbee

Posts: 10
Joined: 8/27/2007
Status: offline

Ok.. I'm new to the land rover kick..but just dident want the same chevy..ford 4x4. just got me a 1990 RRC and well, is it alwasy going to be this hard to find parts..I even went to a rover dealer.. they looked at me like i was talking in a diferent laguage.I'm trying to rerbuild ...just need ( my bad) just want ome 2" kit..and may be some steel rims..plus i know in time i'm going to need parts..I have looked at some links..but i wanted to poll yall to see if anyone has found the best link.. you know the holy garil of 1990 RRC PARTS...or is there one??

Post #: 1

RE: 1990 rover - 8/28/2007 11:14:19 AM

okdiscoguy

Posts: 2485
Joined: 2/16/2007
From: Tulsa, OK
Status: offline

Might post this in the Range Rover section. Look at the top of the general tech help section, there is a list of parts suppliers. I know this is a good place for the whole lift set-up http://lrrforums.com/store/index.php?target=categories&category_id=264. What other parts are you trying to find?

< Message edited by okdiscoguy -- 8/28/2007 11:17:46 AM >

_____________________________

97 Discovery SD-7 156K miles
04 Cadillac CTS 34K miles
Good Oil
number of posts does not = knowledge (unless it is me)

(in reply to newbee)

Post #: 2

RE: 1990 rover - 8/28/2007 2:24:53 PM

newbee

Posts: 10
Joined: 8/27/2007
Status: offline

thank you ..
great site.. just what i was looking for.
next is a switch for the moon roof it works.(sometimes)
master cylinder, I have leak that on a seal on a exiting line or master cylinder went bad. did'nt want to take things apart till i got a manual.

(in reply to newbee)

Post #: 3