P0135

Printable Version

Land Rover Forum >> General Land Rover Forums >> General Tech Help >> P0135

Page: [1] 2   next >   >>

Login Message << Older Topic   Newer Topic >>

P0135 - 3/14/2008 11:20:09 AM    snugg   Posts: 19 Joined: 1/16/2008 Status: offline I have an 2005 RR HSE and the check engine light will come on for a few days and the turn off.  The DTC code that shows up is P0135 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1).Does any one know an easy way to fix the problem.  Do I have to change the sensor? Help please....... Post #: 1

RE: P0135 - 3/14/2008 12:06:23 PM    Disco Mike Posts: 9948 Joined: 4/27/2006 Status: online How many miles on your truck? Are you still in warranty, if so I would suggest you let the dealer handle it under warranty. If not in warranty then you will need to replace 1 or 4 02's depending on your mileage. _____________________________ Mike Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers. 99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45. (in reply to snugg) Post #: 2

RE: P0135 - 3/14/2008 12:17:04 PM    snugg   Posts: 19 Joined: 1/16/2008 Status: offline Mike, I have 53,000 miles so it's out of warrenty.  do you thing i need to replace all 4 o2 sensors or replace them as they begin to fail.  Also is this a complicated task for an average do it your selfer and how much should i expect a dealer to charge me?  thanks. (in reply to Disco Mike) Post #: 3

RE: P0135 - 3/14/2008 12:39:46 PM    Disco Mike Posts: 9948 Joined: 4/27/2006 Status: online I would call the dealers service manager, not the service writer, and ask him if it is covered under the State or Federal emission warranty, it might be. I would look at the exhaust manifold, down to the "Y" pipe, if it looks easy to get to go for it if the dealer won't cover it. At your mileage you would only need the one replaced. _____________________________ Mike Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers. 99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45. (in reply to snugg) Post #: 4

RE: P0135 - 3/19/2008 8:23:04 AM    snugg   Posts: 19 Joined: 1/16/2008 Status: offline Mike, I have noticed the engine light only comes on when the gas tank is near empty.  When i fill up the light goes off after two trips.  Do you think there could there be anything else wrong? (in reply to Disco Mike) Post #: 5

RE: P0135 - 3/19/2008 9:54:58 AM    Disco Mike Posts: 9948 Joined: 4/27/2006 Status: online The 2 should not be related. As for the gas tank, try not to let it go under 1/4 full, it causes overheating and speeds up it's wear. _____________________________ Mike Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers. 99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45. (in reply to snugg) Post #: 6

RE: P0135 - 3/19/2008 10:13:48 AM    snugg   Posts: 19 Joined: 1/16/2008 Status: offline Ok.  thanks again Mike... (in reply to Disco Mike) Post #: 7

RE: P0135 - 3/19/2008 2:42:42 PM    socalrover84   Posts: 59 Joined: 3/18/2008 Status: offline Just my input but 05 LM's are known to have bad cats on their vehicles they will crack just before the convertor and will cause that code to be logged on, and as far as changing all sensors is not really a good idea just swap the sensors side to side and see if the code logs on for the other bank they are interchangable now the banks on the m62 are read backwards. Oh yeah and you can probably get them taken care of by the dealer it falls withing emissions warranty (in reply to snugg) Post #: 8

RE: P0135 - 4/9/2008 12:41:10 PM    snugg   Posts: 19 Joined: 1/16/2008 Status: offline Now I am getting another code which reads " low range/ performance bank 1 sensor 1" so I’m getting ready to order a heated oxygen sensor and hopefully correct the problem. I have two questions. 1. is bank 1 sensor 1 the front drivers side sensor or the front passenger side sensor? 2. do I need a special tool to remove and install the oxygen sensor? Any help would be greatly appreciated. _____________________________ 2005 RR HSE (in reply to socalrover84) Post #: 9

RE: P0135 - 4/9/2008 1:18:16 PM    Disco Mike Posts: 9948 Joined: 4/27/2006 Status: online Bank 1 sensor 1 is the front 02 on the drivers side. I know the mileage doesn't warrant replacing them as a pair, but, I would replace both front 02 to kee everything balanced. Check with Atlantic British, they usually have some of the better 02 prices on line. _____________________________ Mike Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers. 99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45. (in reply to snugg) Post #: 10

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Land Rover Prices

Land Rover
Defender
Discovery
Freelander
Range Rover
Range Rover Sport

Top 10 Posters
disco mike 9948 spike555 3921 okdiscoguy 2462 landzu 2001 05landrover 1072 mikemeyer0 945 darover 778 ajh 708 camdisco24 689 bait 631

New Vendors
AMSOIL - Performance Oil Technology