Land Rover Forum
Land Rover Forums   Land Rover Classifieds   Photo Gallery   Member List   Calendars   Search   Contact Us   Sponsors
Land Rover Lineup   News   Forum FAQ   Land Rover Recalls   TSBs   Timeslips   Register   Login  
 

Changing the Transferbox oil

  Printable Version
Land Rover Forums >> General Land Rover Forums >> General Tech Help >> Changing the Transferbox oil Page: [1]
Login
Message << Older Topic   Newer Topic >>
Changing the Transferbox oil - 4/23/2008 11:10:45 AM   
Captain Ducman


Posts: 15
Joined: 11/5/2006
Status: offline
Ok,

I am most of the way through the 60k mile service and was wondering if anyone had done this and had some "Been the Done that" advise.  My truck is on the lift, we've completed the plugs/wires, the engine flush, oil and filter change, front and rear difs, when my helper had to go back to work.  I am supposed to go back to the shop in a couple of hours to help complete the servicing.

Thanks in advance,
Steve
Post #: 1
RE: Changing the Transferbox oil - 4/23/2008 11:31:54 AM   
unstable

 

Posts: 166
Joined: 4/20/2008
Status: offline
I've done it on other vehicles and I'm preparing to do it on my wifes 01 DII.
If you've got a LIFT it should make life alot easier.  Typically there is not a drain plug for differentials and transfer cases rather a fill.  You're limited to either vacuum pumping the fluid out or siphoning.  Obviously the bigger the hose the better.  I've changed out the fluid on rear-ends before using the typical fish-tank air-hose crap and it's painful...but doable.

Keep sucking the old out until you are reasonably satisfied that you've gotten it all, then refill with new.

I would be interested in seeing what others responses are though.

(in reply to Captain Ducman)
Post #: 2
RE: Changing the Transferbox oil - 4/23/2008 11:51:56 AM   
WolfPack


Posts: 391
Joined: 1/3/2008
Status: offline
I would reccommend actually removing the differential covers...a fluid change is a good time to inspect the ring and pinon, spiders, everything in there that's important.  Also use a can or two of brake cleaner and be sure to get alllll of the old gear oil out before refilling. 

Although if you just want a simple oil swap, siphoning would work ok...but gear oil is pretty viscous to pump..


_____________________________



2001 Range Rover 4.6 SE - Coil Sprung
2000 Chevy Blazer 4x4 4.3L V6 - The Beast

(in reply to unstable)
Post #: 3
RE: Changing the Transferbox oil - 4/23/2008 12:55:04 PM   
llesra


Posts: 301
Joined: 9/6/2006
From: Colorado
Status: offline
there are fill and drain plugs on both diffs and the transfer case so theres no need for suction. there is no diff cover or way to access the gears unless you take the complete third member out. on the transfer case, the drain plug is at the the bottom, where it should be and the fill plug is to the left of the parking brake drum. youll need a pump to add fluid into it.

_____________________________

Arsell
94 disco
97 disco
99 range rover 4.6

(in reply to WolfPack)
Post #: 4
RE: Changing the Transferbox oil - 4/23/2008 1:04:05 PM   
unstable

 

Posts: 166
Joined: 4/20/2008
Status: offline
quote:

ORIGINAL: llesra

there are fill and drain plugs on both diffs and the transfer case so theres no need for suction.


That's a sweet gig!  Most differentials I've worked on only have the fill!  If someone tells me that the transmission has a drain plug I may be in heaven.

not to hijack this thread but is 80/90W synthetic gear oil the recommended stuff for the transfer case and both diffs?

< Message edited by unstable -- 4/23/2008 1:06:30 PM >

(in reply to llesra)
Post #: 5
RE: Changing the Transferbox oil - 4/23/2008 3:35:19 PM   
Disco Mike


Posts: 9372
Joined: 4/27/2006
Status: offline
All Discos have drain and fill plugs on the diffs as well as the t/case, alway had them.
D1's have fill tubes for the tranny while D2's don't, need to ddain then fill them thru the fill plug on the side of the tranny pan.

_____________________________

Mike
Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers.
99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45.

(in reply to unstable)
Post #: 6
RE: Changing the Transferbox oil - 4/23/2008 5:50:39 PM   
Captain Ducman


Posts: 15
Joined: 11/5/2006
Status: offline
Ok,

Project 60k is complete as per the maintenance section of the Rave CD and alot of reading through Disco Mike's and many other's posts. Thank you all!!

The lift makes this a much easier job to tackle, I used a $6 hand pump from Advance Auto Parts. Drain and fill ports for both difs, xfer case, and transmission makes this a very easy job. I spent about $160 in synthetic fluids and sea foam but it sure beats whatever the dealer would've charged me, plus I got to see first hand the magnetic drain plugs and the condition of the life blood coming out of each component. We went so far as to run each fluid through paint strainers to look for possible problems. The biggest thing we found were some thin short shavings from the transfer box and they were trapped on the drain plug, nothing in the fluid. In return I have the peace of mind knowing this has been done and there is no excessive wear going on.

Again thanks to all who have posted on PM of their rovers,

Steve

(in reply to Disco Mike)
Post #: 7
RE: Changing the Transferbox oil - 4/24/2008 5:28:12 AM   
unstable

 

Posts: 166
Joined: 4/20/2008
Status: offline
Thanks for your post bruv.  I'm working toward the 60K checkup on my wifes rig too.  We've only had it since Saturday and I've already put new brake pads all the way around and did the first flush and oil change.

Tonight I'm hoping to rip the front driveshaft out and go get that rebuilt.  I need to find out how to engage the CDL so the rig is still driveable.

I'll have to check the account for $$$ but maybe this weekend I'll embark on draining the diffs and doing the tranny service.

EDIT-->Pertaining to the Discovery II transmission fill plug...I guess that's better than a transmission with just a dipstick and no drain or fill plug.  I absolutely HATE doing tranny services on rigs where you've got to unbolt the pan and splash ATF all over yourself.  Even when I've managed to do this right, I always get covered in ATF.

< Message edited by unstable -- 4/24/2008 5:30:07 AM >

(in reply to Captain Ducman)
Post #: 8
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
 
Land Rover >> General Land Rover Forums >> General Tech Help
Jump to:



Featured Sponsors
Advertising Info

Top 10 Posters
disco mike9372
okdiscoguy2345
spike5552099
landzu1748
05landrover1072
mikemeyer0945
ajh705
darover669
camdisco24632
bait631

New Vendors
AMSOIL - Performance Oil Technology
K&N Engineering, Inc.

Harley Davidson | Honda CBR Motorcycle

Land Rover Forums .com is not affiliated with or endorsed by Ford Motor Company.