Paint Flaking off Door Handles

Land Rover Forums Land Rover Classifieds Photo Gallery Member List Calendars Search Contact Us Sponsors
Land Rover Lineup News Forum FAQ Land Rover Recalls TSBs Timeslips Register Login

Paint Flaking off Door Handles - 2002 RR HSE

Printable Version

Land Rover Forum >> General Land Rover Forums >> General Tech Help >> Paint Flaking off Door Handles - 2002 RR HSE

Page: [1]

Message

<< Older Topic Newer Topic >>

Paint Flaking off Door Handles - 2002 RR HSE - 5/8/2008 5:57:57 AM

jcutter

Posts: 5
Joined: 4/26/2008
Status: offline

Picture says it all. Old coating is peeling off of door handles on my 2002 HSE. Any thoughts? Any good epoxy paints or other solutions to get this looking good again?

Thumbnail Image

Attachment (1)

Post #: 1

RE: Paint Flaking off Door Handles - 2002 RR HSE - 5/8/2008 6:54:22 AM

bhorwhat

Posts: 14
Joined: 10/2/2007
Status: offline

jcutter -
This is a common problem. I had it on my '03 although not as bad. Im the second owner and it would have been covered under warranty but the previous owner never asked for any remediation. Too bad for me.

I corrected the problem myself. The original paint on mine was enamel. I used a lacquer base and clear coat and and it blistered, therefore I had to remove the entire paint system. and redo from scratch. It looks mint again and only took a few hours.

Make sure if you need to do this you get a stripper that is safe for plastics.

Bob

_____________________________

'99 Disco Series 1
'03 Range Rover HSE
'the best 4 x 4's - for me'

(in reply to jcutter)

Post #: 2

RE: Paint Flaking off Door Handles - 2002 RR HSE - 5/8/2008 4:02:17 PM

jcutter

Posts: 5
Joined: 4/26/2008
Status: offline

Thanks Bob. Since I am somewhat of a paint-idiot, can you suggest a brand of either paint or stripper which might be safe?

< Message edited by jcutter -- 5/8/2008 4:14:20 PM >

(in reply to bhorwhat)

Post #: 3

RE: Paint Flaking off Door Handles - 2002 RR HSE - 5/9/2008 5:45:19 AM

Disco Mike

Posts: 8780
Joined: 4/27/2006
Status: online

Check with your local hardware store, there are a couple of paints made specifically to be used on Plastic. These paints are made to penetrate into the plastic.

_____________________________

Mike
Retired service manager. Member of the Solihull Society, NCLR club,past member of the SCLR club and Santa Barbara 4 Wheelers.
99 D2, 3" lift, lockers, H.D. axles, 4:11 gears, Custom front and rear bumpers, Warn winch, HID lights and an Engel 45.

(in reply to jcutter)

Post #: 4

RE: Paint Flaking off Door Handles - 2002 RR HSE - 5/9/2008 8:34:52 AM

bhorwhat

Posts: 14
Joined: 10/2/2007
Status: offline

I used trichloroethane, but I don't think you can get this (I work in a lab). Check with a local paint shop like Mike suggested. They also make an adhesion promoter (primer) for plastics. I used this as well.

Good luck
Bob

_____________________________

'99 Disco Series 1
'03 Range Rover HSE
'the best 4 x 4's - for me'

(in reply to jcutter)

Post #: 5

RE: Paint Flaking off Door Handles - 2002 RR HSE - 5/9/2008 6:53:08 PM

jcutter

Posts: 5
Joined: 4/26/2008
Status: offline

Thanks all! I found another FAQ showing a how-to with Bulldog paint adhesion promoter and autotouchup base and clearcoat paints.

Now the only question is how to remove the outside door handles with the least amount of work. I've done it before on Chevy's, but I am guessing that the panels are a little harder to remove on a RR. If anyone has any links to other how-tos on removing the door handles on a 2002 RR please post a link.

Thanks.

(in reply to bhorwhat)

Post #: 6