Induction cleaning, conflicting instructions (Full Version)

Land Rover Forum >> Vehicle Line Up >> Discovery

Induction cleaning, conflicting instructions

  

Phototone -> Induction cleaning, conflicting instructions (5/11/2008 9:44:41 AM)

I seem to recall, on this forum the general consensus for using SeaFoam is to allow the engine to slowly suck in a whole can, and then run the engine until the exhaust clears. The SeaFoam can says to suck-up about 1/3 of a can, then shut the engine off for five minutes or so. Then restart and allow the exhaust to clear. Is one way better than the other?

  
Disco Mike -> RE: Induction cleaning, conflicting instructions (5/11/2008 10:13:46 AM)

SeaFoam used to say to use the whole can and have changed their wording because people were so concerned about the smoke.
So, buy 2 cans, 1 for the tank, 1 for the induction, run it thru slowly, then shut off the engine for 30 minutes, may take that time to clean your t/body, then go drive it.

  

Page: [1]

Return to Land Rover Forums home page or view the Full Version of this page.